High Power Additional Loom D6 Connector
(Controller to Battery)
UK stock and immediate shipping
Controller side only (please see other listing for battery side)
Cables
You will notice that our 72v batteries come with two discharge cables. This is to “parallel” the output power and share the load. The power from the battery to the controller is known as Direct Current “DC” discharge, which can create heat at full power. Having two cables shares this power and vastly reduces the heat created.
Power from the controller to the motor is known as Phase Current, where the power flicks on and off very fast in phases, which creates less heat. If using the battery at full power, we highly recommend using the extra set of discharge cables provided and running your set up with two discharge leads from the battery to controller (extra lead provided on solo battery purchases, or already attached to the controller on full kit purchases).
We manufacture these to go with our 72v batteries (included with all original battery purchases).
Supplied with upgraded high power 8 AWG silicon cable.
One end with the ring terminals bolts direct to your controller :
Red: positive
Black: negative
The other end with the D6 connector goes straight into the battery.
Please remember to use the below connection sequence:
Connection order:
#01, Turn off trip by flicking red switch to the left
#02, Plug in original power lead to battery (battery and power leads only plug in one way)
#03, Turn on red trip switch by flicking to the right.
#04, Plug in final power lead.
Warranty:
Warranty terms, please check here:
https://electroncycles.com/warranty-policy/
Disclaimer is available here:
https://electroncycles.com/terms-and-conditions/
